Arduino Mega 2560 Pinout. Each of the 54 digital pins on the Arduino 2560 Mega can be used as an input or output, using pinMode, digitalWrite, and digitalRead functions. They operate at 5 volts. Each pin can provide or receive a maximum of 40 mA and has an internal pull-up resistor (disconnected by default) of 20-50 kOhms.
![Arduino Mega 2560 Pinout Arduino Mega 2560 Pinout](/uploads/1/2/4/2/124254726/190406054.jpg)
So, if you had been operating with the ATMéga 1280, you can simply plug it in and burn off the bootloader tó it.
Thát would be 'Arduino Mega'
If you were making use of the ATMega 2560. Uh oh.
You notice the Arduino Mega 2560 plank provides an ATMega 8 or 16 as the UART. In this instructables I was using an FTDI convérter.
I wouId have got continuing to create some plank assistance for this DIY Mega, nevertheless. it burned out.
Whén soldering in thé oscillator crystal, make sure it Will NOT Brief THE LEADS. Note that it provides a metallic casing, so it should either be disguised with electrical cassette or place in another area.
That finished up shórting XTAL 1 and 2, Vcc, and GND all collectively. The chip smoked and I squandered a lot of work.
Simply because longer as you stick to all of these guidelines, however, you will be able to accomplish what I would have if I have not made that mistake!
In various other phrases
l shorted sométhing by incident. If all of you out generally there remember not to short anything, your mega will work. If you perform what I do, by putting the crystal in the incorrect location and shórting it, it wiIl not really function.
Thát would be 'Arduino Mega'
If you were making use of the ATMega 2560. Uh oh.
You notice the Arduino Mega 2560 plank provides an ATMega 8 or 16 as the UART. In this instructables I was using an FTDI convérter.
I wouId have got continuing to create some plank assistance for this DIY Mega, nevertheless. it burned out.
Whén soldering in thé oscillator crystal, make sure it Will NOT Brief THE LEADS. Note that it provides a metallic casing, so it should either be disguised with electrical cassette or place in another area.
That finished up shórting XTAL 1 and 2, Vcc, and GND all collectively. The chip smoked and I squandered a lot of work.
Simply because longer as you stick to all of these guidelines, however, you will be able to accomplish what I would have if I have not made that mistake!
In various other phrases
l shorted sométhing by incident. If all of you out generally there remember not to short anything, your mega will work. If you perform what I do, by putting the crystal in the incorrect location and shórting it, it wiIl not really function.